Case 5:19-cv-00036-RWS Document 356-3 Filed 06/29/20 Page 1 of 5 PageID #: 12848
`Case 5:19-cv-00036—RWS Document 356-3 Filed 06/29/20 Page 1 of 5 PageID #: 12848
`
`EXHIBIT 34
`
`EXHIBIT 34
`
`

`

`Case 5:19-cv-00036-RWS Document 356-3 Filed 06/29/20 Page 2 of 5 PageID #: 12849
`
`MVC-FD83/FD88
`SERVICE MANUAL
`
`US Model
`Canadian Model
`AEP Model
`UK Model
`E Model
`Australian Model
`Hong Kong Model
`Chinese Model
`Korea Model
`MVC-FD83/FD88
`Tourist Model
`MVC-FD88
`
`Ver 1.0 1999. 05
`
`This service manual contains information
`for Japanese model as well.
`
`Photo: MVC-FD88
`
`SPECIFICATIONS
`
`MICROFILM
`
`DIGITAL STILL CAMERA
`
`APL-MAXELL_01147532
`
`

`

`Case 5:19-cv-00036-RWS Document 356-3 Filed 06/29/20 Page 3 of 5 PageID #: 12850
`
`(cid:129) Floppy disk that can be used by the MVC-FD83/FD88
`(cid:129) Size :
`3.5-inch
`(cid:129) Type :
`2 HD
`(cid:129) Capacity :
`1.44 MB
`(cid:129) Format :
`MS-DOS format
`(512 bytes × 18 sector)
`(FD can be formatted by the MVC-FD83/FD88)
`
`Destination
`
`Table for differences of function
`MVC-FD88
`Model
`MVC-FD83
`US, CND, AEP, UK, E,
`US, CND, AEP, UK, E,
`AUS, HK, CH, KR, JE
`AUS, HK, CH, KR
`1/3.6-inch CCD
`1/3-inch CCD
`Image device
`8 ×
`3 ×
`Lens
`16 ×
`Digital zoom 6 ×
`CD-228
`CD board
`CD-229
`FU-137
`FU board
`FU-135
`PK-48
`PK board
`PK-47
`RL-56
`RL board
`RL-54
`Note: MVC-FD83K/FD88K are the same as MVC-FD83/FD88
`except accessories and packing materials.
`
`MVC-FD83K : MVC-FD83 + Accessory kit
`MVC-FD88K : MVC-FD88 + Accessory kit
`
`MVC-FD83K
`
`MVC-FD88K
`
`J
`
`J
`
`1/3-inch CCD
`3 ×
`6 ×
`CD-229
`FU-135
`PK-47
`RL-54
`
`1/3.6-inch CCD
`8 ×
`16 ×
`CD-228
`FU-137
`PK-48
`RL-56
`• Abbreviation
`AUS : Australian model
`CH : Chinese model
`CND : Canadian model
`J
`:
`Japanese model
`HK : Hong Kong model
`KR : Korea model
`JE
`: Tourist model
`
`SAFETY-RELATED COMPONENT WARNING!!
`COMPONENTS IDENTIFIED BY MARK ! OR DOTTED
`LINE WITH MARK ! ON THE SCHEMATIC DIAGRAMS
`AND IN THE PARTS LIST ARE CRITICAL TO SAFE
`OPERATION. REPLACE THESE COMPONENTS WITH
`SONY PARTS WHOSE PART NUMBERS APPEAR AS
`SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB-
`LISHED BY SONY.
`
`ATTENTION AU COMPOSANT AYANT RAPPORT
`À LA SÉCURITÉ!
`LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE !
`SUR LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE
`DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ
`DE FONCTIONNEMENT. NE REMPLACER CES COM-
`POSANTS QUE PAR DES PIÈCES SONY DONT LES
`NUMÉROS SONT DONNÉS DANS CE MANUEL OU
`DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
`
`SAFETY CHECK-OUT
`After correcting the original service problem, perform the following
`safety checks before releasing the set to the customer.
`
`1. Check the area of your repair for unsoldered or poorly-sol-
`dered connections. Check the entire board surface for solder
`splashes and bridges.
`2. Check the interboard wiring to ensure that no wires are
`“pinched” or contact high-wattage resistors.
`3. Look for unauthorized replacement parts, particularly transis-
`tors, that were installed during a previous repair. Point them
`out to the customer and recommend their replacement.
`
`4. Look for parts which, though functioning, show obvious signs
`of deterioration. Point them out to the customer and recom-
`mend their replacement.
`5. Check the B+ voltage to see it is at the values specified.
`6. Flexible Circuit Board Repairing
`• Keep the temperature of the soldering iron around 270 ˚C
`during repairing.
`• Do not touch the soldering iron on the same conductor of
`the circuit board (within 3 times).
`• Be careful not to apply force on the conductor when sol-
`dering or unsoldering.
`
`– 2 –
`
`APL-MAXELL_01147533
`
`

`

`MVC-FD83/FD88
`Case 5:19-cv-00036-RWS Document 356-3 Filed 06/29/20 Page 4 of 5 PageID #: 12851
`SECTION 1
`This section is extracted from
`GENERAL
`instruction manual.
`
`1-1
`
`APL-MAXELL_01147539
`
`

`

`MVC-FD83/FD88
`Case 5:19-cv-00036-RWS Document 356-3 Filed 06/29/20 Page 5 of 5 PageID #: 12852
`SECTION 2
`DISASSEMBLY
`• This set can be disassembled in the order shown below.
`
`Set
`
`Cabinet (Front) Section
`(Page 2-1)
`
`Cabinet (Rear) Section
`(Page 2-1)
`
`Lens Block
`(Page 2-1)
`
`Battery Holder
`(Page 2-3)
`
`FC-70 Board
`(Page 2-3)
`
`Floppy Disk Drive
`(Page 2-3)
`
`Motor Units
`(Page 2-2)
`
`CD-228/229 Board
`(Page 2-2)
`
`FU-135/137 Board
`(Page 2-3)
`
`PK-47/48 Board,
`LIQUID CRYSTAL INDICATION
`(Page 2-4)
`
`Flash Unit
`(Page 2-3)
`
`RL-54/56 Board
`(Page 2-3)
`
`Note: Follow the disassembly procedure in the numerical order given.
`2-1. CABINET (FRONT) SECTION
`
`2-2. LENS BLOCK
`
`1 Two screws
`(M2)
`
`9 Cabinet (rear) section
`
`7 Cabinet (front) section
`
`6 Two screws
`(M2)
`
`2 Two screws
`(M2)
`
`2 Flexible board
`(CN101)
`
`4 Lens block
`
`3 Claw
`
`3 Screw
`(M2)
`
`5 Screw
`(M2)
`
`4 Two screws
`(M2)
`
`8 FP-116 flexible board
`(CN501)
`
`1 FP-115 flexible board
`(CN001)
`
`2-1
`
`APL-MAXELL_01147554
`
`